PARD NV007 Klippverschluss Adapter montieren

By Professor Optiken - Zieloptiken, Ferngläser & Reflexvisiere | Published: 2026-10-25

Category: Product Reviews

Learn how to mount the PARD adapter with clip lock for NV007A, NV007V, and Sytong HT series. Step-by-step instructions with common mistakes to avoid.

Quick answer

Mount the PARD clip-lock adapter by selecting the correct size ring for your eyepiece, attaching it to the adapter body, then clipping it onto the NV007 or Sytong device. Avoid overtightening and check for a snug fit without forcing.

Why the clip-lock design matters

The PARD clip-lock adapter replaces the traditional screw-on approach with a quick-release mechanism. This makes it faster to attach or detach the night vision unit, but it also requires careful alignment to avoid damaging the adapter or the device.

Choosing the correct ring size

The adapter comes with two ring options: 45 mm (for eyepieces 39–45 mm) and 51 mm (for 42–51 mm). Measure your eyepiece outer diameter before starting. Using the wrong size can cause the adapter to sit loosely or not clip on at all.

Mounting steps

Select the ring size: Measure your eyepiece outer diameter. Use the 45 mm ring for 39–45 mm eyepieces, or the 51 mm ring for 42–51 mm eyepieces. A common mistake is assuming all eyepieces are the same size. If unsure, measure twice with a caliper.
Attach the ring to the adapter body: Place the ring onto the adapter body so that the three screw holes align. Hand-tighten the screws evenly, but do not overtighten – the ring should still rotate freely. Overtightening can strip the threads. Stop tightening as soon as you feel resistance.
Slide the ring onto the eyepiece: Gently push the ring over the eyepiece until it sits flush. If it is too tight, use one of the three included inserts to reduce the inner diameter. Do not force it. Forcing can scratch the eyepiece coating.
Lock the ring in place: Tighten the three screws firmly but gently, using a cross pattern to ensure even pressure. Check that the ring does not move when you rotate the adapter body. Recheck after a few shots; vibration can loosen screws.
Clip the NV007 device onto the adapter: Align the clip on the NV007 or Sytong device with the slot on the adapter. Press down until you hear a click. Pull gently to confirm it is secure. A common mistake is not pressing fully, causing the device to fall off. Test the clip lock before using the setup in the field.

Product facts

PARD Adapter mit Klippverschluss für PARD NV007A, NV007V/V2/V2-P und Sytong HT66/77/88/99: The PARD adapter with clip lock fits eyepieces up to 45 mm or 51 mm, depending on the version, and includes three inserts to adjust the inner diameter. This means you can fine-tune the fit for different eyepiece sizes, but you must select the correct ring (45 mm or 51 mm) at the start.
PARD Adapter mit Klippverschluss für PARD NV007A, NV007V/V2/V2-P und Sytong HT66/77/88/99