PARD Okularschutz für NV Serie richtig montieren
By Professor Optiken - Zieloptiken, Ferngläser & Reflexvisiere | Published: 2026-10-21
Category: How-to Guides
Learn how to properly install the PARD replacement eyecup on your NV series night vision device. Step-by-step instructions with common mistakes to avoid.
Quick Answer
Mounting the PARD replacement eyecup on your NV series device takes less than a minute. The key is aligning the ventilation system correctly and seating the rubber cup fully over the ocular housing.
Why the right installation matters
The PARD NV series eyecup is designed with a built-in ventilation system that absorbs recoil and protects your eye during shooting. If the cup is not fully seated or is twisted out of position, the ventilation channels won't work properly, and the cup may slip off during use.
Because the eyecup is a direct replacement part, there are no tools or adhesives required. The rubber cup stretches over the existing ocular housing and holds by friction alone. That makes installation simple, but also means you need to pay attention to alignment.
Step-by-Step Installation
- Remove the old eyecup: If you are replacing a damaged or lost eyecup, gently peel the old rubber cup off the ocular housing. Start at one edge and work your way around. Do not use sharp tools that could scratch the housing. Check that the ocular housing is clean and free of debris before installing the new cup.
- Align the ventilation system: Hold the new eyecup so that the ventilation slots (small cutouts on the inner rim) face downward or toward the direction of the recoil. On most PARD NV devices, this means the slots align with the bottom of the ocular housing. Refer to your device manual for the exact orientation. Installing the cup with ventilation slots facing up can reduce recoil protection and cause the cup to slide off.
- Seat the eyecup fully: Starting at the top edge, stretch the rubber cup over the ocular housing. Press evenly around the circumference until the cup sits flush against the housing. The rubber should not be twisted or bunched at any point. A partially seated cup may feel secure at first but can pop off during recoil. Run your finger around the rim to confirm it is fully engaged.
Product Facts
- PARD Ersatzteil - Okularschutz / Augenmuschel für NV-Serie: This ocular shield fits all PARD NV series devices: 007A, 007V, 007S, and 007SP (including laser rangefinder variants). It uses a ventilation system to absorb recoil and protect your eye. The ventilation system only works when the eyecup is oriented correctly. A misaligned cup can reduce recoil protection and cause discomfort during extended use.
PARD Ersatzteil - Okularschutz / Augenmuschel für NV-Serie
